Scientific Articles with Pro-C-epT equipment

CRAFT project CR1460-91 - Drying powders from slurries using microwaves in a single closed vessel. Microwave winner.
M. De Wit, ProCepT, European Commission

Spray Drying Scale-Up from mg to kg Scale with a Hydroxypropyl
Methylcellulose Acetate Succinate (HPMC-AS) Solution

J. Vanwesenbeeck, F. Van der Gucht, M. Gil

Particle Engineering with a lab scale spray-dryer
Filip Van der Gucht, Ignace De Ridder

Optimization of Process Conditions for Spray Drying drug-loaded Poly lactic-co-glycolic acid (PLGA) microspheres
G. Serneels, F. Van der Gucht, G. Van den Mooter

An approach to maximise drug loading for oral tablets via formulation and process design
Pfizer, by Dennis Golchert, Ian Smales, Brunel Eiliazadeh, Laura Musgrave, Elena Razzano

Ready to use pellets with controlled properties. Elaboration in a Mi-Pro high shear mixer granulatior
Emilie Chevalier - GEFSOD Groupe d'études sur la fonctionnalisation des solides divisés; m. Viana, C. Pouget, D. Chulia

Is the small scale predictive of large scale performance? Case study from High Shear Wet Granulation and Fluid Bed processing
Merck and co, by Mr. Conrad Winters

Microwave Assisted Vacuum Drying and End Point Determination Using Mass Spectrometry, Part I
Kevin Hettenbach, David J. am Ende, Eric Dias, Steven J. Brenek, Catherine Laforte, and Stanley M. Barnett

Microwave Assisted Vacuum Drying and Endpoint Determination Using Mass Spectrometry, Part II, On-Line Moisture Content Profiling
Kevin Hettenbach, David J. am Ende, Eric Dias, Steven J. Brenek, Catherine Laforte, and Stanley M. Barnett

Increasing process understandig of wet granulation by spectroscopic methods and dimension reduction tools
University of Helsinki byAnna Cecilia Jorgensen

Comparison of torque measurements and near-infrared spectroscopy in characterization of a wet granulation process
Astra Zeneca, University of Helsinki, Copenhagen by Anna Cecilia Jřrgensen, Pirjo Luukkonen, Jukka Rantanen, Torben, Schćfer, Anne Mari Juppo, Jouko Yliruusi

Effect of process pararameters on characteristics of theophylline containing pellets prepared in a HIGH SHEAR granulators
University of Pécs, institute of Pharmaceutical Technology, Semmelweis University, Department of Pharmaceutics

The effect of vessel material on granules produced in a high-shear mixer
University of Groningen by Anneke M. BouwmanMarinella R. Visser, Anko C. Eissens, JohannesWesselingh and Henderik W. Frijlink

Physical and thermal characterisation of Precirol^(R) and Compritol^(R) as lipophilic glycerides used for the preparation of controlled-release matrix pellets
Laboratory of Pharmaceutical Technology, University ULB of Brussels, by Hamdani J, Moes AJ, Amighi K.

Scaling-up of a lactose wet granulation process in Mi-Pro high shear mixers
University of Ghent by Ameye D, Keleb E, Vervaet C, Remon JP, Adams E, Massart DL

Influence of chopper and mixer speeds and microwave power level during the high-shear granulation process on the final granule characteristics
Laboratory of Pharmaceutical Technology, University of Gent, Belgium by Kiekens F, Cordoba-Diaz M, Remon JP.

The theoretical basis for scaling-up by the use of the method of microwave granulation
Meditop Pharmaceutical Co.,Pilisborosjeno by David A, Benkoczy Z, Acs Z, Greskovits D, David AZ.

Development and evaluation of prolonged release pellets obtained by the melt pelletization process
Laboratory of Pharmaceutical Technology, University ULB of Brussels by Hamdani J, Moes AJ, Amighi K

An oral controlled release matrix pellet formulation containing nanocrystalline ketoprofen
Laboratory of Pharmaceutical Technology, University of Gent, Belgium byVergote GJ, Vervaet C, Van Driessche I, Hoste S, De Smedt S, Demeester J, Jain RA, Ruddy S, Remon JP.

Ready to use pellets with controlled properties
Emilie Chevalier

Particle Engineering with Lab Scale Spray-Dryer
Filip Van der Gught, Ignace De Ridder. Departement Chemical Engineering, DE NAYER INSTITUTE [Mechelen, Belgium]

An Energy-Based Population-Balance Approach to Model Granule Growth and Breakage in High-Shear Wet Granulation Processes
Anish P. Dhanarajan and Rebanta Bandyopadhyay. Michigan Pharmaceutical Sciences, Pfizer Global R&D, Kalamazoo, MI

Ready to use pellets with controlled properties
Emilie Chevalier

Particle Engineering with Lab Scale Spray-Dryer
Filip Van der Gught, Ignace De Ridder. Departement Chemical Engineering, DE NAYER INSTITUTE [Mechelen, Belgium]

An Energy-Based Population-Balance Approach to Model Granule Growth and Breakage in High-Shear Wet Granulation Processes
Anish P. Dhanarajan and Rebanta Bandyopadhyay. Michigan Pharmaceutical Sciences, Pfizer Global R&D, Kalamazoo, MI

Page last updated : 20-07-2011